Customers pay great attention to the selection and installation of plasma polishing machine, because these will affect the future use of polishing machine. Today, we will summarize some experience for the installation personnel.

1. firstly, it is necessary to comprehensively analyze the soil pressure resistance and water level at the installation site. The installation scheme can be determined only if the installation and use requirements of polishing machine are met.

2. when installing polishing machine, try to clean the ground as far as possible to avoid the difficulty of cleaning the machine installation.

3. the installation shall avoid high voltage transmission line and interference to the electronic polishing machine.

4. independent power supply is required to avoid sharing with other high-power electrical appliances.

5 polishing machine installation needs relatively spacious installation site, and it is important to have enough operation space.

6. polishing machine in rainy, humid and alkali areas cannot be installed on the ground, otherwise, many problems such as ventilation and drainage should be considered.

7. the polishing machine shall not be installed on the air outlet, otherwise, the polishing machine can not operate well when the wind is blowing.

In fact, the selection of installation position of plasma polishing machine is very important. Only the correct selection of installation location can ensure the service life of polishing machine.

The plasma polishing machine is simple in structure, and it needs to be used correctly. Daily maintenance is done. The following points should be noted in the use:

1. When the continuous working time of plasma polishing machine is too long, the friction heat generation temperature of polishing roller is high, which is easy to scald the leather surface, and it needs to be cooled before operation.

2. Before and after work, the surface of polishing roller shall be cleaned and waxed to keep the roller surface smooth and dust free.

3. In use, control the pressure of the feed roller properly to avoid too much resistance and the electric heating is easy to burn. Do a good job in the lubrication of the rotating parts of the drive chain, and keep the transmission accurate and reliable.

4. Plasma polishing machine to keep backward tilt, rear wheel must be stored on the ground; The power cord of polishing machine shall be stored well, and it must be wrapped on the suspension hook, and then wipe the surface layer of power cord with a wet cloth. If the power cord is damaged, it shall be replaced in time and can not be used again; The surface of polishing machine and each sheet metal cover, especially motor and heat dissipation equipment surface must be kept clean and polishing consumables powder shall be cleaned regularly.

5. The whole machine of plasma polishing machine shall check screw, belt, tightness of polishing machine, and if loose, adjust to the proper point to check the wear degree of each bearing. If there is any damage, replace it. The guide rail shall be cleaned and the guide rail shall not be equipped with polishing consumables powder. After the cleaning, lubricating oil shall be added to make up, handle, handball, screw, nut and other machine parts shall be added. Keep the machine in order. Clean polishing machine accessories, clean, tidy and rust proof.